FUJIKURA SPEEDER NX WHITE DRIVER SHAFTS

SPEEDER NX WHITE
CREATE SPEED. GOLDEN RATIO.

Upgraded DHX to match the low-mid kick point. The birth of a new low-mid kick point shaft that suppresses energy loss at impact and reduces ball dispersion.

By lowering the tip rigidity and increasing the rigidity from the middle to the butt section, the SPEEDER NX WHITE is designed to make it easy to catch and launch the ball. It is a new low-mid kick point shaft that combines stability in the swing path with high reproducibility at impact.
It also features a newly angled DHX. In addition to the conventional increase in clubhead speed, by adjusting the angle to suit the low-mid kick point, it suppresses energy loss (deflection) at impact and reduces ball

PRODUCT FEATURES :

● DHX
Taking advantage of the design freedom that characterizes carbon shafts, Fujikura has newly laminated a second bias layer at an angle other than 45°. This technology achieves an increase in clubhead speed through the combination of the conventional 45° layer and the second bias layer. In the SPEEDER NX WHITE, adopting a new angled layer has successfully reduced ball dispersion.

● VTC (Variable Torque Core)
By increasing the torsional rigidity from the tip to the middle section, the stability of the shaft's behavior during the swing is improved. This achieves a highly efficient impact.

SPECIFICATIONS :

SHAFT TIP TRIMMING

The following tip trimming instructions are suggestions only.  We generally do not recommend tip trimming on a driver or 3 wood shafts based on the shaft composition and how tipping could affect performance. We recommend that you consult your custom fitter or club-builder for the best tip trimming suggestions based on your individual swing and desired results. 

In general, tip trimming can be used to achieve a stiffer shaft profile, lower launch, and/or lower spin. Tip trimming 1“is equivalent to one flex.  For example, if you wanted to stiffen your S flex to an X flex then you would tip trim 1”. If you prefer to play shaft in between S and X flex, you would tip trim 1/2”.