Epoxy Curing System

Heat is transferred progressively and evenly from the pegs to the clubhead hosel via conduction. Radiated heat from the peg is not damaging to adjacent surfaces and does not blister paint, weaken shafts or embrittle shaft adapters.

The upright curing position reduces the incidence of gap formation between the hosel and ferrule, and minimizes the possibility of off-center shaft bonding, thereby reducing the amount of rework involved.

Key Features:

• Controlled heating for up to 1 hour at 50~200?C / 122~392?F.
• Reduces cure time to full strength from 7 days to 30 minutes*
• Reduces time to handling strength from hours to minutes*
• Obsoletes difficult to handle shafting epoxy with short pot life.
• Heat insulated, lever actuated pegs for quick loading.
• Upright clamping pegs keep shaft centered over the hosel.
• Good for pre-heating adapters prior to shaft extraction.
• Holds up to 7 clubs with ample spacing between clubs.
• Powerful, low maintenance 500W sealed cartridge heater.
• Ideal for tour vans and trailers with on board generators.
• Compact wall mount installation reduces footprint!

Please Note: Heat accelerated curing of epoxy adhesives may not be suitable for all formulations. Please consult manufacturer?s data sheets for specific instructions.

The Golfmechanix epoxy cure system is a time and temperature controlled golf club curing rack designed to speed up the hardening of high strength 2 parts epoxy adhesives to full strength within minutes instead of hours especially on cold days or when ambient room temperature is below 20?C / 68?F.